(1) Always check the environmental conditions of the soft starter to prevent it from operating above its permitted environmental conditions. Be sure to check the soft starter for objects that prevent it from ventilating and cooling, and ensure that there is enough space around the soft starter (greater than 150mm).
(2) Regularly check whether the terminals of the distribution line are loose, and whether the components in the cabinet are overheated, discolored, or smelly.
(3) Clean the dust regularly to avoid heat dissipation, prevent the thyristor from being damaged due to excessive temperature rise, and avoid leakage and short circuit accidents caused by dust.
Cleaning dust can be done with a dry brush, or with a tiger blow and a vacuum cleaner. For large pieces of dirt, it can be removed with an insulating rod. If conditions permit, it can be blown off with compressed air of about 0.6 MPa.
(4) Pay attention to the operation of the fan at ordinary times. Once the fan speed is found to be slow or abnormal, repair it in time (such as removing grease, dust, lubricating oil, and replacing damaged or deteriorated capacitors). Replace the damaged fan in time. If the soft starter is used without a fan, the thyristor will be damaged.
(5) If the soft starter is used in a damp environment or is prone to condensation, it should be dried frequently with an infrared bulb or a hair dryer to remove moisture to avoid leakage or short circuit accidents.
0.8mm Pin Header
Antenk 0.8mm Pitch Male Header series is a fine pitch, low profile, single/dual/three/four row, PCB mounted connector set intended for limited space applications or where total weight is a factor. Our specially tooled insulators and contacts maintain consistent high quality through our automated production processes. Each series is available in thru-hole PCB or SMT mounting and plated tin, gold or selective gold as specified.
0.8mm Pin Header Options
Number of Rows
1/Single
2/Double
3/Three
4/Quad
Number of Positions
2 Position
3 Position
4 Position
5 Position
6 Position
8 Position
10 Position
12 Position
14 Position
15 Position
16 Position
17 Position
20 Position
Termination Style
SMD/SMT
Through Hole
Mounting Angle
Right Angle
Straight
0.8mm Pin Header Specifications:
Material: Standard Hi-Temp insulator: Nylon 6T, rated UL94V-0
Insulator Color: Black
Contacts: Phosphor Bronze
Plating:
U = Gold over nickel underplate
SG = Gold over nickel underplate on
contact area, tin over copper underplate on tails.
T = Tin over copper underplate overall.
Electrical:
Operating voltage: 250V AC max.
Current rating: 1 Amp max
Contact resistance: 20 mΩ max. initial
Insulation resistance: 5000 MΩ min.
Dielectric withstanding voltage: 1000V AC for 1 minute
Mechanical:
Mating durability: 500 cycles min.
Temperature Ratings: Operating temperature: -40°C to +105°C
Max process temp: 230°C for 30 ~ 60 seconds (260°C for 10 seconds)
Soldering process temperature: 260°C
Packaging:
Anti-ESD plastic bags or tubes
Approvals and Certifications:
UL Recognized File no. E224053
Pin Header,0.8Mm Male Header,0.8Mm Pin Header,0.8Mm Male Header Pins,0.8mm Pitch Pin Header,SMT 0.8mm Pin Header, THT 0.8mm Pin Header
ShenZhen Antenk Electronics Co,Ltd , http://www.coincellholder.com