Generally, when going to the 4s shop, the owner will leave the car in the store, and all the in and out of the workshop are the after-sales personnel to operate.
Because of the mistakes made by the after-sales personnel, the car damage is not a minority, but most of them are concealed.
The foreign 4s shop staff will also make mistakes. The Mercedes-Benz G500 was hit by an Australian employee when he entered the workshop.
The G500 is a high-end model in the G class, and the foreign price is equivalent to more than one million yuan. The accident may not be technically bad, but it is difficult for people who have not opened this high-powered car to drive.
And the G500 body weighs more than 2.7 tons, and the ability to hit the wall can be said to be a lever.
Fortunately, this employee only hit a partition wall, and the loss is not too big.
After the car was opened, the front of the car was complete. On the one hand, it was because the G-class body was hard, including the car lights were not damaged.
The owner of the vehicle gave up the claim to the mechanic under the knowledge and accepted the compensation plan of the 4s shop - free paint polishing and maintenance.
But if it is a Mercedes-Benz S-class that is out of control, I am afraid that this employee has a big problem.
The picture shows the Mercedes-Benz G-class, this car has not been replaced for 30 years, known as the king of off-road vehicles.
It is also popular in China, mainly because of its unique and domineering appearance, although the body is not large but it attracts local attention.
After more than 30 years of development, the G class has formed a huge car system. Not only the common four-door version, but also the two-door version, the convertible version, the 6-wheel pickup and even the single-row small card version.
The Mercedes-Benz G500, which was out of control, was equipped with a 4.0T V8 twin-turbo engine. Although the weight of the car was as high as 2.7 tons, it was only 6.7 seconds because the horsepower was too strong.
Sunket has launched HJT solar modules, which have the following 10 advantages:
1) Higher conversion efficiency: higher installed capacity within a limited installation area and lower BOS cost;
2) Higher reliability: Our product design is mature and has been tested by the market. Compared with large-sized components, it is more effective in resisting wind load and snow pressure, and it is not easy to cause frame damage, glass burst, and a large number of hidden cracks to cause excessive attenuation of components. ;
3) Low attenuation rate: 90% power line quality guarantee is still available after 30 years of use;
4) Low temperature coefficient of -0.24%: 2%-3.9% higher power generation per watt compared to conventional PERC;
5) Better low-light power generation performance: HJT adopts N-type silicon wafer technology, which generates 1% more electricity per watt compared to single crystal PERC;
6) No PID, no LID attenuation: lower attenuation of components in the whole life cycle and higher power generation;
7) Double-sided rate as high as 90%+: the backside of our heterojunction modules can have more than 90% and at least 423W of backside power generation, and the power generation superposition is higher after double-sided installation;
8) Lower LCOE: At present, compared with PERC single crystal technology, our heterojunction technology is more advanced, achieving the lowest LCOE of power generation, faster payback period and maximum benefit;
9) Good matching: suitable for photovoltaic grid-connected inverters and photovoltaic tracking brackets used in domestic mainstream;
10) Cost-effective.
HJT Solar, HJT Solar Panel, HJT Solar PV Module, HJT Solar Module, HJT PV Module
Wuxi Sunket New Energy Technology Co.,Ltd , https://www.sunketsolar.com